Skip to main content

What Can I Do to Prevent a Sump Pump Failure?

What can I do to prevent a sump pump failure?

The best way to prevent sump pump failure is with planning and maintenance. It’s true that your sump pump could be defective, but more often than not, problems arise due to a lack of maintenance or careless installation.

There are several reasons why your sump pump might be failing, and identifying these problems is key to preventing them. The most common cause of sump pump failure is a power outage. Sump pumps depend on your house for power, and blackouts can be problematic.

There are two ways to deal with this problem. First, it’s never a bad idea to have a backup generator in your home, specifically for instances like this. The other, less costly way to prevent sump pump failure during blackouts is to purchase a sump pump battery backup that operates when your power is out. Sump pump battery backups can cost anywhere between $275 and $500 plus labor to install. While the initial cost might not be attractive, they’re the best way to prevent basement flooding during a power outage.

Your sump pump might also be failing due to improper installation. Your unit could be too big or small for your house, which makes your pump more prone to failure. Make sure that your pump is the right for your home and the amount of ground water it will need to pump.

You may also have a sump pump switch problem, which is common because the float switch the moving part that gets the most use on a sump pump so it is often the part that wears out first.

Finally, maintenance is key to preventing sump pump failure. If you haven’t heard your pump run recently, test it by running a water hose into the sump pit or pouring in a five gallon bucket of water. When the water reaches a predetermined level, the pump should turn itself on, pump out most of the water then turn itself off again. If you have a backup pump, test it a few times each year to determine if it will work in the event of a blackout. And make a note of when the battery is due to be replaced. The backup pump won’t work if the battery dies. When testing your pump, make sure the discharge line’s airhole is clear. The float switch on the pump shouldn’t be restrained so make sure electrical cords aren’t tangled around the switch. Finally, remove any gravel in the sump pit and check that the screen that covers the sump pump’s water intake is clear of debris.